Subject: Re: Napco 1000E, 1016E, 1008 panels


The 1000e is rather simple, buy a 40 pin chip clip and put it on the
large chip on the board (powered down of course), power up the panel
and short the 5th pin from the bottom left to the 5th pin top right.

hold down the 9 key for 3 seconds until it beeps, hold down the 8 key
until it beeps and put in the default installer code 4 5 6 7 8 9

your in programming, take off the jumper and view the installer code
or program as normal.

on the 1008 there is an empty socket for an eprom pointing up , with a
wire short the bottom right socket to the 2nd from the top right
socket and do the 9 key, 8 key then default code.

this works with both the 1008e and the 1008lkdl

now the 16 I gotta go look it up, pretty much the same principle,
watch what your doing or you can short the wrong pins and damage the
board.



On 20 Dec 97 05:43:30 GMT, "jdgroh" <jdgroh@zoomnet.net> wrote:

>Please Help,
>
>There is a local Company going out of business slowley and they will not
>give up there dealer code I have a lot of them to reprogram is there any
>way to default this? 
>
>I will buy the software, or is it hardware? 
>
>Someone please help.
>
>
>
>jdgroh@yahoo.com